SoundXtreme ST-X300 3 Way Electronic Car Stereo Crossover for sale in Pine, AZ
SoundXtreme ST-X300 3 Way Electronic Car Stereo Crossover Dash Mount Bass Knob Remote Frequency Response 10Hz-30kHz Including Power Adapter Connector 60dB Separation A crossover is an electronics device that takes a single input signal and creates or three output signals consisting of separated bands of high-, mid-, and low-range frequencies. The different bands of frequencies feed the different speakers, or "drivers," in a sound system: tweeters, woofers, and subwoofers. Think of a crossover network as an audio traffic cop, directing highs to your tweeters, midrange to your woofers, and low bass to your sub.Without a crossover, a messy, "traffic jam" results. Your midrange and sub duplicate too many of the same frequencies and your sub wastes time trying to put out high notes it wasn't meant to handle. A "fatal pile-up" could also occur, with your tweets being destroyed by some renegade tractor-trailer of a bass note thumping along in the wrong audio lane.#Features:Front Channel High Pass Frequency ExtenderSubwoofer Frequency SelectorBass Boost Frequency ControlBass Boost level ControlPhase InverterSubwoofer Stereo/Mono SwitchFront Channel Output Gain ControlLeft/Right Front Channel Output TerminalsRear Channel Output Gain ControlLeft/Right Rear Channel Output TerminalsSubwoofer Output Gain ControlLeft/Right Subwoofer Output TerminalsSubwoofer Output Level Remote Control Terminal#Technical Details:Crossover Frequencies (continuously variable): Front High-pass: (x1): 32-800Hz (x10): 320 - 8KhzRear High-pass: 32-800HzSubwoofer: 50-160HzCrossover slope rate: 12dB per octave 2nd Order Butter WorthSubwoofer boost: Single octave 0dB to 12dB (variable) at 40 - 120Hz(Variable) Input Impedance: >10K OhmsOutput Impedance: Front Channel High Pass Frequency Extender, Subwoofer Frequency Selector. Bass Boost Frequency and Level Control. Phase Inverter Subwoofer Stereo/Mono Switch. Subwoofer boost: Single octave 0dB to 12dB (variable) at 40 - 120 Hz(Variable). Subwoofer Output Level Remote Control Terminal.
|
|
 |